How to Repair a Saab 93 Key Fob
There is a good chance that the key fob of your Saab 9-3 is defective in its electronic chip. The metal part of classic car keys was easy to duplicate, however, modern keys have an immobilizer system to protect your vehicle.
The first step in determining the reason your key fob won't be working is to replace the battery on your key fob. This is a cheap and easy fix.
How do you program the Saab 93 Key Fob
Saab key fobs can allow you to control your car's doors, trunk and engine. They can also unlock the fuel door and activate a panic button. Remotes can also be programmed with the car's transmitter. Plug the key into the ignition and turn the switch ON. Follow the Tech2 instructions until you have programmed the keys that you wish to use with the vehicle.
New Saabs had two keys, whereas used ones often come with only one. You can add another key by replacing the transmitter (which includes the transponder) and programming it with a handheld computer called Tech-2 Tech-2 at your Saab dealer. You'll also need a new key to match the old one in order for it to work. This is a cost-intensive task however, it's less expensive than replacing your entire CIM system with locking cylinders and if you lose the only working key.
Saab Key fob replacement 93
Saab owners who lost their keys should purchase an additional one as soon as they can. The key fob isn't as traditional keys made of metal used in cars from 20 years ago, but it is an electronic device that communicates with the car through a specific chip. This is what allows the car to recognize the key fob and prevents it from being copied. It is possible to do this at a dealer, however the cost could be high. You can avoid this problem if you purchase a new Saab key on the internet.
It will make your vehicle safer should you lose it. A burglar is more likely find a spare key than one that was stolen. The majority of thieves don't have the tools required to copy these more modern keys. G28 Car Keys would need a specialized device to copy them, but even that is not a guarantee for protecting your car from theft.
A spare key will also save you money in the process of replacing the SAAB 9-3 remote's battery. The electronic units of the keyfob have batteries, and eventually they'll fail. It is fairly easy, but you must be careful not to harm the electronics in the case. You can view videos on Youtube to learn how to do this job, like those made by Cyclone CID.
Saab 93 key fob battery
It's probably time to replace the battery on your key fob in case you've noticed the response time is slow. While there may be other reasons for the delay an unresponsive battery is the most likely culprit. This is a low-cost and easy solution, so don't hesitate.
The first step is removing the backup key from the fob. To do this, press firmly on the Saab logo and pull it off the key ring loop. Insert a flathead phillips screwdriver in the indentation of the key fob case. Turn the screwdriver around to separate the case. The plastic shouldn't be damaged if you don't use too much force.
You can see the electronic components inside the case when you open it. The circuit board is joined to the case using metal retaining clips. If these clips are rusty, or dirty the fob will not perform as it should. It is possible to clean them with ruby alcohol. This is an interim solution. The clips will eventually wear out and will need to be replaced.
Test the door locks of your car with the backup remote prior to you replace the battery. If it's working correctly it's likely that the issue lies related to your primary key fob. Replacing the battery will resolve the issue, but if you're experiencing delays whenever you lock or unlock the doors, it's possible that something else is wrong with your car.
Saab keyfob 93 case
If your key fob's case is showing signs of wear, a simple solution is to buy a new. They can be purchased on the internet and can be attached to your remote control. All you require is a flathead screwdriver and a small amount of patience. Put the flathead screwdriver in the slot in the middle of the case and gently split it open. Be careful not to damage the limiters which hold the battery. After taking off the emergency key and badge, the new case is able to be inserted into existing electronics. There is no need to reprogramme the electronics.
The most effective key fob cover features a lining specifically designed to prevents signals from reaching the key fob. This is important because it's these signals that allow your vehicle to start. Some of these cases are constructed with silver layers, whereas others are made from copper to make transmissions more distort.
Key fob covers are also an excellent way to protect your keys from damage. It can help you keep the track of your key fob, and aid in finding it in the dark when you get to your vehicle. A good key fob cover can protect your keys from theft, and it will also add a bit of style to your keychain.
